نمایشگر پرینتر سه بعدی مدل RAMPS1.4 LCD 12864

نمایشگر پرینتر سه بعدی مدل RAMPS1.4 LCD 12864

configuration

RepetierUpload the firmware, power off the Arduino, connect the panel, reapply power, and everything should work
==> REMEMBER TO INSTALL U8glib to your ARDUINO library folder: http://code.google.com/p/u8glib/wiki/u8glib
Change “#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER” (just remove the // at the beginning)
Installation: In "Configuration.h”
Marlin V1 (new)
----------
http://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller#Marlin_V1_.28new.29
----------
Upload the firmware, power off the Arduino, connect the panel, reapply power, and everything should work
==> REMEMBER TO INSTALL U8glib to your ARDUINO library folder: http://code.google.com/p/u8glib/wiki/u8glib
1.Change "#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER" (just remove the // at the beginning)
In "Configuration.h"
Marlin V1 (new)
Ramps plug and play, but need to modify the firmware to support, to Marlin as an example

Features
1. Using large screen 12864LCD
2. Back integrated SD deck, slice files into the SD card, select the corresponding file on the LCD can print
3. Product comes with encoder, you can achieve parameter adjustment, and file selection to print
4.ramps plug and play, but need to modify the firmware to support
5. Support Chinese font, modify Marlin firmware can display Chinese menu, modify the method of their own research, do not provide technical support
The RAMPS LCD12864 kit includes the following
1.RAMPS LCD12864 motherboard 1
2. L-type adapter board 1
3. FC cable 2

:Note

SD card can be inserted offline printing, SD card please bring their own, this product does not contain

product manual
The intelligent controller includes an SD card reader, a rotary encoder and a 12864 LCD display. You can easily connect it to your RAMPS 1.4 board using the "smart adapter" included
This panel connects your RAMPS 1.4 after you do not need your PC, your SD card smart controller powered. Further further operation, such as calibration, the axis movement can be done with only the rotary encoder with the intelligent controller. No computer graphics 3D design, just use the G code design stored on the SD card
Ramps plug and play, but need to modify the firmware to support, to Marlin as an example
Marlin V1 (new)
In "Configuration.h"
1.Change "#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER" (just remove the // at the beginning)
==> REMEMBER TO INSTALL U8glib to your ARDUINO library folder: http://code.google.com/p/u8glib/wiki/u8glib
Upload the firmware, power off the Arduino, connect the panel, reapply power, and everything should work